mitche
Junior Member
Posts: 70
|
Post by mitche on Jan 30, 2012 21:52:01 GMT -5
Any one using all upper case. I know if you use symbols there is a smaller limit but not sure about using all upper case. Starting to think I'll use upper case for better viewing.
|
|
|
|
Post by Jimm Reifsnyder on Feb 3, 2012 14:42:19 GMT -5
I always capitalize the first letter
|
|
Bailey
Full Member
San Diego Lutron Representative
Posts: 172
|
Post by Bailey on Feb 3, 2012 18:57:13 GMT -5
Mitch- It's my understanding that when you type the "label" you wish to engrave duting the program phase, it will accomodate for the size if the letters.
|
|
|
|
Post by alsmith99 on Feb 12, 2012 16:10:41 GMT -5
This is taken from the recommended Pdf engraving form and will only allow input based on these parameters. Has anybody had any issues ordering engraved buttons ordered directly from the program?
• 10 characters maximum** (including spaces)
• 7 characters maximum** (including spaces) when
using ALL CAPS or icon
|
|
mitche
Junior Member
Posts: 70
|
Post by mitche on Feb 13, 2012 19:20:50 GMT -5
The reason i started this thread was because I'm sure I've seen HW kp programed with all caps. It has been a while since I've seen one and I don't have access to the software. As you can see by the pic it is still possible to have more than 10 char. Just a minor bug but slows me down when i have to count. I don't like to count I have people for that. I like the all caps idea for better viewing. I still have older customers that have to bend down to read some of the buttons. Attachments:
|
|
