|
|
Post by RA2guy on Feb 20, 2013 16:59:25 GMT -5
I have a "goodnight" scene that turns off all lights in the house immediately except for (2) loads. After 30 seconds the other (2) loads turn off. I programmed this 2 years ago. How did I accomplish this? All of the fade rates are set to the same .2 seconds. I have reviewed the scene setup and can't figure out how I accomplished it.
|
|
|
|
Post by sbsmarthomes on Feb 20, 2013 17:48:45 GMT -5
Wish I could help... I've done the same thing on a past project and when I went back I couldn't remember how I did it. I think the delay is adjustable up to 4 hrs, but I don't remember how to set it for devices in a scene. Was wondering if somehow the feature disappeared from later software releases?
|
|
|
|
Post by Coop on Feb 20, 2013 19:52:32 GMT -5
Do you have a 3rd Party control system integrated with the RA2 Main repeater? I've done this using a 3rd part control system to monitor the system, and then issue additional command once it see's something happen. just my .02
|
|
|
|
Post by RA2guy on Feb 20, 2013 20:11:57 GMT -5
SBSmarthomes, you nailed it!! This is a pic of the programming section in 4.0.10.  Now, how do I make a change in 6.0?  |
|
|
|
Post by rdgerken on Feb 20, 2013 20:46:57 GMT -5
Right click on the columns where it says Level and Fade, and select "Show Delay."
|
|
|
|
Post by drsung on Feb 20, 2013 21:12:13 GMT -5
rdgerken, THANKS!!! You are awesome!
Just to clarify, I went to a different computer to find the 4.0.10 software and that was the latest version installed on that computer. That's why it delay column wasn't showing in the 6.0.0 version on my new computer.
|
|
Bailey
Full Member
San Diego Lutron Representative
Posts: 172
|
Post by Bailey on Feb 21, 2013 8:10:18 GMT -5
Just a heads up, I would check to make sure that the delay is occurring. Using the iPad app and adding a delay results in the delayed load command being ignored. I have been told by several people that Ra2 does not have he sequential capabilities of HomeWorks.
|
|
|
|
Post by rdgerken on Feb 21, 2013 12:14:10 GMT -5
Just a heads up, I would check to make sure that the delay is occurring. Using the iPad app and adding a delay results in the delayed load command being ignored. I have been told by several people that Ra2 does not have he sequential capabilities of HomeWorks. Delay works fine on my RA2 system, at least from the integration interface. |
|
|
|
Post by sbsmarthomes on Feb 21, 2013 12:42:46 GMT -5
I can confirm the delay works when programmed using Essentials. Like the original poster I couldn't find how I'd done this in the past and the post from rdgerken explained how to get the delay column visible again. It seems you have to add the delay column each time you open the software...
|
|
Bailey
Full Member
San Diego Lutron Representative
Posts: 172
|
Post by Bailey on Feb 22, 2013 0:48:41 GMT -5
I edited a scene via the iPad today. Previously this resulted in the command being dropped or forgotten. The delay function now works from the app as well.
|
|
