|
|
Post by fiasco on Sept 8, 2010 16:08:52 GMT -5
Are there any plans to permit manually setting the ip of the main repeater in RA inclusive so that the RA system can be programmed remotely?
I realize you have to initialize each device initially but it would be nice to be able to tweak scenes or dimmer level programming remotely after the initial install.
|
|
Eric
New Member
Posts: 3
|
Post by Eric on Dec 14, 2011 13:47:20 GMT -5
So now with 5.xx Inclusive software, you can remotely program. Problem is this... customer has a local subnet of 192.168.87.xxx and a different brand vpn router than the one recommended in the vpn app note rev.c
it seems that remote vpn programming requires the main repeater to have an address of 192.168.100.151-199
Is that true?
Tried a PPTP vpn with the repeater ip address on his subnet (outside DHCP range)... ipod app works great over 3g vpn, but I can't get remote programming to work.
Will i have to ask the customer to change his subnet?
|
|
|
|
Post by fiasco1111 on May 25, 2012 12:47:24 GMT -5
i'm trying to do a house on 192.168.100.205 and 206 (two repeater system) and can't see the repeaters through the VPN.
I can telnet into them, ping them etc through the vpn but inclusive can't see them
|
|
